CONCRETE HALF BLOCK NEAR ME FULL

Using a mason’s line as a guide for the remaining block, continue building the wall until it is complete. To set the next course of block, apply a one-inch thick mortar bed along top of the first course.Īt the end of the wall, set an “8x8x8” half block into the mortar bed with the smooth side facing out. Repeat steps 6 and 7, adjusting the blocks to be flush and level continue this process until the first course is completed. Using the same process, set the opposite corner block. The mortar should be workable but firm enough to support the weight of the block.īutter the inside end of the first block and then press the block into the mortar bed to create a 3/8 inch mortar joint. Furrow the mortar bed using the tip of the trowel to create a “v” to help distribute the mortar evenly. For Concrete Pipe and Precast inquiries, contact your regional County Materials facility: Florida - (352) 343-8488. The proper consistency is achieved when the wet mortar will “hang” on a trowelĭampen the footing surface with water and place a one-inch bed of mortar on the footing. We supply the greater Midwest, including Florida, Illinois, Indiana, Iowa, Minnesota, Missouri, and Wisconsin. American Precast specializes in manufacturing a high-quality precast concrete. Call us today at 800.691.7118 for more information.

Learn why more people are turning to precast concrete for wall solutions.

CONCRETE HALF BLOCK NEAR ME FULL

TIP: when preparing to place a trowel full of mortar, gently “snap” the trowel downward to removeĪny excess mortar. All of our concrete products are manufactured in our Southern California facility, then shipped and installed directly at your project site. Snap a chalk line on each side of the block wall as a reference line. Lay out the block, making sure to leave a 3/8 inch gap between the blocks to allow for the vertical mortar joints (i.e., a typical 8x8x16 block is actually 15-5/8 inches long and 7-5/8 inches high to accommodate the mortar joint).

Rebar should be placed in every other masonry core to provide structural support.įor masonry cores over 4 inches wide, QUIKRETE Core Fill Grout – Coarse should be poured around the rebar for masonry cores under 4 inches wide, QUIKRETE Core Fill Grout-Fine should be used. NOTE: it is important to check local building codes for construction requirements in your area.įor load-bearing walls, tie rods should be set a minimum of 6 inches into the concrete footing before it is set. Economical - up to half the cost of cast-in-place walls Designable - build as a MSE (tieback) retaining wall (up to 50 tall) or a gravity retaining wall. Footings should be a minimum of twice the width of the concrete block (i.e., a typical 8x8x16 block would require a 16-inch wide footing) and extend below the frost line. When working with cement-based products, always wear eye protection and waterproof gloves.Įnsure a solid footing.

Concrete half block near me